Inspect the fuel system before every season and look at the visible parts each time you go out: lines, primer bulb, clamps, filter, tank and fittings. You are checking for cracks, soft spots, leaks, water and fuel smell. Fuel leaks on a boat are a fire and explosion risk, so anything that looks wrong gets fixed before the engine runs.
What the fuel system does
Fuel travels from the tank through a pickup and fuel line, usually a primer bulb and a water-separating filter, then a fuel pump to the engine. Gasoline vapors are heavier than air and collect in the bilge, so a boat is less forgiving of a leak than a car. A water-separating filter catches water and debris before they reach the engine. Many engines also have a second, engine-mounted filter. Your owner’s manual shows the layout and the service schedule.
Tools and supplies
- Flashlight and inspection mirror
- Replacement filter and gaskets for your engine, matched by model
- Marine-rated fuel hose and hose clamps, if needed (use only hose rated for marine fuel)
- A container for fuel, absorbent pads, gloves and safety glasses
- A fire extinguisher within reach, and good ventilation
Inspection steps
- Work with the engine off and cool, the battery switch off, and no one smoking or using flame nearby. Open the engine hatch and ventilate before you look.
- Smell the bilge. A gasoline smell is a reason to stop and find the source.
- Follow each fuel line from the tank to the engine. Look for cracks, brittleness, swelling, soft spots, chafe marks and stains. Squeeze the line. A line that is hard, sticky or crazed has aged out.
- Check every clamp and fitting for tightness and corrosion. Dry, hard hoses at a fitting often leak first.
- Squeeze the primer bulb. It should firm up. Cracks, leaks or a bulb that will not hold pressure means replace it.
- Look at the water-separating filter. A clear bowl shows water or sediment, and some have a drain. Replace the element on the schedule in your manual, and sooner if you find water or debris.
- Inspect the tank where you can see it: seams, fittings, the vent line, and the fill hose. A clogged vent can make the engine stall or starve.
- After any work, run the engine and watch every fitting for weeping. Check again after the engine has been shut off.
Water and fuel quality
Ethanol-blended fuel can absorb water and can age quickly when it sits. Check your engine’s manual for the fuel it allows. If a boat sits, a fuel stabilizer made for marine use helps, and a fresh fill at the start of the season is better than old fuel. If you suspect water in the tank, do not run the engine; have a shop drain and flush it. See also our guide on filling a boat with gas properly.
What Havasu heat does to fuel parts
Havasu heat is the backdrop for all of this. Go Lake Havasu’s climate table (credited to usclimatedata.com) shows an average July high of 109 degrees and an average August water temperature of 87 degrees (Go Lake Havasu), and the National Weather Service notes that the warmest temperature ever recorded at one of its official observing sites, 128 degrees on June 29, 1994, came from Lake Havasu City. Heat ages rubber hoses and bulbs, hardens clamps and gaskets, and raises vapor pressure in the tank. A boat in direct sun builds pressure, so open the fill cap slowly and let any pressure out. Hot fuel can vaporize in the line and cause hard starting or stalling, often called vapor lock, so check that lines are away from heat sources and in good shape. Shade and ventilation help.
When it needs a shop
- Any active fuel leak, or fuel in the bilge
- Hoses that are cracked, hardened or not marked as marine fuel hose, especially in an older boat
- Water in the tank, a corroded tank, or a tank that is leaking at a seam
- Repeated stalling or hard starting that new filters do not fix
- Any work on an inboard or sterndrive fuel tank or fuel pickup
Why it matters when you buy
Ask about the fuel system on any used boat and look at the lines yourself. We do a full inspection before the paperwork is final and show you the reconditioning and maintenance we performed. Browse our boats.
Related guides
How to fill boat gas properly, Carbon monoxide dangers on a boat, How to winterize a boat engine, Pre-season checklist.
Next step
Call us at (928) 453-8833, text (928) 732-2281, or stop by 1680 Industrial Blvd. Hours are Monday to Saturday 8 to 5 and Sunday 9 to 2. You can see our current boats, and if you have one to sell, we consign it with no fees. If you want to know what yours is worth first, start with a value estimate.
Common questions
How often should I replace the fuel filter?
Follow your owner’s manual, and replace it sooner if you find water or sediment. Many owners swap it at the start of each season.
How can I tell if a fuel hose is bad?
Look for cracks, swelling, soft or sticky spots, hardening and stains at the fittings. Replace any hose that looks aged, with marine-rated hose.
Is old gas bad for my engine?
It can be. Gas that sits can lose potency and collect water, especially ethanol blends. Check your manual and use fresh fuel.
What does a gas smell in the bilge mean?
Stop and find the source before starting the engine or using electrical items. Ventilate the compartment and call a shop if you cannot find it.
Can I fix a fuel leak with tape or sealant?
No. A fuel leak needs a proper repair with marine-rated parts, and an active leak should be fixed before the engine runs.
