← Back to the Blog

How to Trim a Boat Engine

Trim sets the angle of the outboard or sterndrive leg, which changes the angle of the bow. Trim down to get on plane and in turns, then trim up a little at cruising speed until the boat runs level and smooth. Too far up makes the bow porpoise or the prop blow out.

What trim does

The trim switch on your throttle handle or dash raises and lowers the engine leg a few degrees. Trimmed down, the thrust pushes the bow down. Trimmed up, thrust is more level and the bow rises. Boats with inboard engines usually use trim tabs instead.

Check your owner's manual and the engine maker for the trim range and any marks on the engine or gauge. Different engines and boats behave differently.

Trimming, step by step

  1. Start fully trimmed down before you leave the dock or accelerate. The bow gets pushed down, and the boat gets on plane faster.
  2. Add power smoothly until the boat is on plane and the bow settles.
  3. Trim up a little at a time. Watch the bow, the ride, the speed and the sound. Pause after each adjustment, because the boat takes a moment to respond.
  4. Stop when the boat feels light and quiet. The right trim is where the boat is fastest at that throttle setting, is smooth and does not hunt up and down.
  5. Trim down again before you slow, turn sharply or enter a wake.

Signs you are trimmed wrong

  • Too far down: the bow plows, the boat feels heavy, spray flies, fuel use goes up and steering feels hard.
  • Too far up: the bow rises and bounces (porpoising), the boat feels loose, the prop howls or the engine revs without speed (ventilation or cavitation), and the stern can slide in turns.

Conditions change the setting

  • Chop or a head wind: trim down to keep the bow from slapping.
  • Following sea or flat water: trim up a little for efficiency, but watch for the bow lifting.
  • Passengers aft: weight moves the bow up. Trim down, or move people forward.
  • Turning: trim down a little, because a high-trimmed leg can lose grip.
  • Shallow water, launching and landing: trim up so the lower unit clears the bottom, then trim down in water that is deep enough to run. Make sure the prop clears the bottom before you move.

Mistakes

  • Running trimmed up all the time. It looks fast and can be unsafe.
  • Not trimming down before slowing, so the bow drops hard.
  • Trimming up when the boat is already skipping.
  • Forgetting to trim up and tilt the engine when you are trailering. Arizona's handbook says to tilt and secure the engine to increase clearance (Arizona Game and Fish boater handbook).
  • Adjusting by feel only. Learn the gauge and the marks on your engine and note them.

Matching engine and boat

The best trim is a good hull and prop match. We are an authorized Mercury and Volvo Penta dealer. If your boat feels hard to trim or the ride is rough, ask a marine technician to check the prop and the setup. Browse used boats for a boat that suits how you use the lake.

Related guides: Prop inspection and replacement · How to drive a pontoon boat · How to tow a wakeboarder

Common questions

When do I trim down?

When you accelerate, turn, slow down or run into chop, so the bow stays down and the boat grips.

When do I trim up?

Once on plane and at cruising speed, a little at a time, until the boat runs level and smooth.

How do I know I have too much trim?

The bow porpoises, the prop slips or howls, or the boat feels loose in turns.

Do inboards have trim?

Usually they use trim tabs. Check your owner's manual for your boat.

Should I tilt the engine for trailering?

Yes. Arizona's handbook says to tilt and secure the engine to increase clearance, and check your manual for any locking device.

Next step

See what is on the lot in our used boat inventory, or call (928) 453-8833, text (928) 732-2281 or stop by 1680 Industrial Blvd in Lake Havasu City (Monday to Saturday 8 to 5, Sunday 9 to 2). Have a boat, pontoon, jet ski or trailer to sell? We consign it with no fees: we agree on a fair market value with you, and you get a check within 10 business days after the deal is funded.

Browse Boats Consign Yours