← Back to the Blog

Hull Cleaning and Waxing: Protecting Your Boat from Havasu Sun

Wash the hull after every outing, remove mineral scale and stains when they appear, and wax on a schedule that keeps the gel coat sealed. In Havasu, sun and warm water do more damage than the waves do, and a good wax is the cheapest protection you can buy for fiberglass.

What waxing does

Gel coat is the colored outer layer on most fiberglass boats. It is porous at a microscopic level, and sun slowly oxidizes it into a chalky, dull surface. Wax or a marine sealant fills and protects it, so dirt and UV have a harder time getting in. Cleaning without protecting leaves the surface exposed. Waxing over a dirty or oxidized surface seals in the problem.

Tools and supplies

  • Boat wash soap (not dish soap, which strips wax)
  • Soft wash mitt, soft brush, microfiber towels
  • A cleaner for hard water spots or scale, safe for gel coat
  • Rubbing compound and polish if the surface is chalky
  • Marine wax or sealant, and foam or microfiber applicator pads
  • Shade, a hose and plenty of clean water

Steps in order

  1. Work in shade on a cool surface. Hot gel coat dries soap and wax before you can work them. In summer, start early.
  2. Rinse the hull to knock off dust and grit, then wash from the top down with boat soap and a soft mitt. Grit rubbed across gel coat scratches it.
  3. Rinse well and dry with microfiber towels so minerals in the water do not leave spots.
  4. Treat hard water spots or scale with a gel coat-safe cleaner as the label directs. Do not leave it to dry on the surface.
  5. Check the surface. If it looks chalky or dull, use compound and then polish to bring back the color. A fresh gel coat that is still glossy can skip this step.
  6. Apply the wax or sealant in thin coats, one section at a time. Follow the product’s directions for cure time before buffing.
  7. Buff off with clean microfiber towels, turning them often.
  8. Clean and protect the vinyl, hardware and rub rail with products made for them, and keep wax off non-skid, where it makes a slippery surface.

What Havasu sun and water do

Havasu heat is the backdrop for all of this. Go Lake Havasu’s climate table (credited to usclimatedata.com) shows an average July high of 109 degrees and an average August water temperature of 87 degrees (Go Lake Havasu), and the National Weather Service notes that the warmest temperature ever recorded at one of its official observing sites, 128 degrees on June 29, 1994, came from Lake Havasu City. Hard sun fades and chalks gel coat, especially dark colors, and warm water speeds the growth of film on the waterline. Lake water leaves mineral spots that bake in when it dries on a sun-heated hull, which is why you rinse and dry the boat before it sits. Wax more often than you would in a mild climate, and check your wax manufacturer’s guidance for the interval. If the boat is stored, covered or under a roof is easier on the hull than open sun. See our guide on storing a boat in Havasu for the summer.

Mistakes to avoid

  • Using dish soap or household cleaners that strip protection or stain
  • Waxing in direct sun on a hot hull
  • Using a power buffer on edges or thin gel coat without experience
  • Dry-wiping a dusty hull, which scratches it

When it needs a shop

  • Deep chalking or color loss that compound does not bring back
  • Spider cracks, blisters, or soft spots in the laminate
  • Large areas that need professional compounding, wet-sanding or a respray

A well-kept hull when you shop

A glossy hull tells you something about how a boat was cared for. When you look at a used boat, check shaded corners against sun-facing sides. Browse our boats, or see Barletta and Bentley pontoons.

Related guides

Gel coat repair, Storing a boat or RV in Lake Havasu for the summer, Upholstery care and UV protection.

Next step

Call us at (928) 453-8833, text (928) 732-2281, or stop by 1680 Industrial Blvd. Hours are Monday to Saturday 8 to 5 and Sunday 9 to 2. You can see our current boats, and if you have one to sell, we consign it with no fees. If you want to know what yours is worth first, start with a value estimate.

Common questions

How often should I wax my boat?

Follow your wax maker’s guidance and check the finish. When water no longer beads and the surface looks dull, it is time. Havasu sun usually means more often than in mild climates.

Can I use car wax on a boat?

Marine products are made for gel coat and water exposure. Use one made for boats and follow its directions.

How do I remove hard water spots?

Rinse and dry the boat promptly after use, and use a gel coat-safe cleaner on spots that have set. Follow the label.

Do I wax the whole boat, or only the hull?

Wax the gel coat above the waterline, including the sides and deck, but keep wax off non-skid areas.

Is a boat cover worth it?

Covers and shaded storage cut UV exposure, which is the biggest enemy of gel coat in Havasu.

Browse Boats Consign Yours